FEIT dimmers: Difference between revisions
Brian Wilson (talk | contribs) Created page with "== Martin Jerry S-01 switches == 2021-11-18 I have one converted to ESPHome and installed (laundry room). Three more to go. I soldered a header onto the back of each control..." |
Brian Wilson (talk | contribs) mNo edit summary |
||
| Line 1: | Line 1: | ||
My understanding is that many IoT home control products get rebranded that are made by Tuya. | |||
In any case however it comes to be, many products are Tuya inside, that is, they work through the cloud-based Tuya management app. | |||
This means when for example when you are sitting on your couch and it's getting dark and you want to switch on your living room light via Home Assistant, the commands have to go up to Tuya's web site and then back down through your gateway to your living room. Since this offends my sense of efficiency and privacy, I want to install ESPhome on all my Tuya devices. | |||
I bought them with this in mind. | |||
== Martin Jerry S-01 switches == | == Martin Jerry S-01 switches == | ||
| Line 4: | Line 10: | ||
I soldered a header onto the back of each controller at the pads marked CN-1 and used Dupont wires to connect it to the programmer (which is just a 3V3 UART-USB really.) | I soldered a header onto the back of each controller at the pads marked CN-1 and used Dupont wires to connect it to the programmer (which is just a 3V3 UART-USB really.) | ||
The Espressif Programmer was not pulling GPIO0 down so I had to unhook that wire and manually ground the input. | The Espressif Programmer was not pulling GPIO0 down so I had to unhook that wire and manually ground the input. | ||
== Feit Electrics dimmers == | == Feit Electrics dimmers == | ||
Revision as of 20:20, 18 November 2021
My understanding is that many IoT home control products get rebranded that are made by Tuya. In any case however it comes to be, many products are Tuya inside, that is, they work through the cloud-based Tuya management app.
This means when for example when you are sitting on your couch and it's getting dark and you want to switch on your living room light via Home Assistant, the commands have to go up to Tuya's web site and then back down through your gateway to your living room. Since this offends my sense of efficiency and privacy, I want to install ESPhome on all my Tuya devices. I bought them with this in mind.
Martin Jerry S-01 switches
2021-11-18 I have one converted to ESPHome and installed (laundry room). Three more to go.
I soldered a header onto the back of each controller at the pads marked CN-1 and used Dupont wires to connect it to the programmer (which is just a 3V3 UART-USB really.) The Espressif Programmer was not pulling GPIO0 down so I had to unhook that wire and manually ground the input.
Feit Electrics dimmers
These are a good price but I'm disappointed that I will have to remove the CPU from the board to reflash them.
https://community.smartthings.com/t/costco-cheap-feit-smart-dimmer-wifi/208142
https://community.home-assistant.io/t/costco-feit-smart-dimmer-tuya-convert-tasmota/151390/5
Deployed in bathroom, kitchen island, breakfast area, living room, dining room. I just replace one in guest bathroom with a Maestro motion sensor switch, so now it's a spare.
I am going to pull apart the spare to see if I can flash it.
Tasmota - https://github.com/blakadder/templates/issues/402 says it's unstable.
https://github.com/nuttytree/ESPHome-Devices https://github.com/cbpowell/ESPSense/wiki
