3D design example

The problem

We got a bowl from a rejects pile from a neighbor who does porcelain ceramics. It's nice, but the handle on the lid is too small for human fingers.

So this is the story of using a $2000 Makerbot Replicator 2 to fix a $5 bowl. :-) This is the story of most of my 3D printing projects so far...

Here is the bowl. The lid is askew a bit because the lid from solution #1 is hiding underneath.

• CAD software: OpenSCAD
• Printer: Makerbot Replicator 2
• Filament: Dark blue PLA, white nylon

Solution #1, a new lid

Here is the bowl and a lid I printed for it shortly after I got the printer. It is one of my first designs.

Problem #1: The printer is not big enough so I had to make "vents" on each side.

Problem #2: When used in a microwave. steam from heated food is absorbed into the PLA, so it warps.

This PLA is not food grade so I did not really want it in contact with food anyway.

Solution #2

This is the idea we came up with yesterday. Make a knob that attaches to the existing handle but is easy to grip. It's outside the bowl, so no problems with food contact and no contact with steam so (hopefully) no warping.

Design issues

So far nearly everything I print requires several iterations. This one was no exception.

Design #1 - One piece, all PLA

This one has fingers that are supposed to grip the knob. They are too brittle, so when I tried to snap the knob onto the lid, they snapped off.

PLA is brittle but has a nice hard smooth surface.

On the other hand nylon is soft and flexible. I just got some nylon filament (Taulman 618). This inspired me to try making a two piece part. Nylon fingers to grip the handle on the lid, and a PLA knob to hold the fingers in place.

Design #2 - PLA + Nylon

PLA knob

Nylon insert

To understand why design #2 fails, you have to think about how 3D printing works. Software converts your 3D model into layers. A thin bead of plastic is squirted out an extruder (just like a glue gun) to form each layer.

This means when I tried to push sideways on the fingers, they just parted on the join between the layers. Snapped right off!

Design #3 - PLA + Nylon strip

To get around the shear problem, I printed a flat nylon strip. Then I wrap it around the lid handle, and push the PLA knob down over it.

This works because when building up the flat strip, the successive layers are run at angles, the first layer is at 45 degrees and the next is at -45, so the resultant strip is very flexible and can be bent into a tube.

It works!