Travel
TO DO
- Check tire pressure
- Remove luggage rack
- Mount bike rack
- Charge batteries for BT keyboard
- Charge battery in emergency phone
- Charge HT batteries
Garmin - load pocket queries
Hacking
- SenseCAP Indicator and cables
- Seeed CANBUS adapter
- Hookup Grove to CANBUS
- OBD-II to CANBUS
- Laptop and charger
- Laptop adapter (USB)
- Comp notebook
- USB3 hub
- 5V supply
- M5StickC with micropython and PIR hat
- M5 Atom Echo speaker
- 3 x USB-C cables
Raspberry Pi
- Pi 4
- 4" monitor
- Logitech KBD and mouse and USB dongle
- USB3 drive
Tools
- screwdrivers
- needle nose pliers
- small cutters
- red voltmeter
- usual tool kit in bag, screwdrivers, torx drivers, usb cables
CanBus
I got an OBD2 extension cable with 90 degree ends to make a low profile connection. I cut the cable in half. (Photo!) Now I have a connector with a 12" cable ready to use.
Termination: https://electronics.stackexchange.com/questions/470382/can-bus-termination-resistors-for-can-logger-device
I don't think I need termination as long as my cable is less than 0.5m long. (It was 18" but I snipped it down to be on the safe side.)
1 --
2 --
3 -- GND --
4
5
6 -- CANH --
7
8
9 -- "Vendor option" -- Brown
10 -- J1850 bus (Ford, Mazda) -- Yellow
11 -- Vendor option
12
13
14 -- CANL -- Green
15 -- Blue
16 -- 12V always on -- Brown
The only ones that matter to me are CANH and CANL. I can use GND and 12V to power my hardware.
MCP2515
Seeed Xiao
I intend trying this one first because it's got a more commonly used chip on it.
https://www.14core.com/wiring-the-mcp2515-shield-with-obd-on-arduino/ connector info
https://www.14core.com/wiring-the-mcp2515-controller-area-network-can-bus-diagnostics/
https://github.com/kvba1/ESP32-MCP2515-OBD2-CANBUS ESP32 + MC2515
https://github.com/yogiD/MCP2515-OBD Arduino + MCP2515
GD32E103CA
Seed + Grove from Longan Labs https://github.com/Longan-Labs/Serial_CAN_FD_Module
