Maker Camp 2015

Crickets thesis paper http://www.kaiser-media.de/thesis/thesis/cover.htm

A different one: http://cricket.csail.mit.edu/ indoor location

Digikey 10F322 processor in DIP package is $.58 in qty 25 2 disposable AAA cells $1.16 for 2

Allelectronics.com

Piezo $.75 self adhesive

cds resistor 1.10

2 AAA battery holder w leads .80

$4.34 total

Maker Camp supplies

• 1 Arduino Uno, based on the Atmel ATMega328, like this FutureKit Temperature Controller
• 1 16x2 LCD display, LED backlight, parallel interface, TOPWAY LMB162ABC http://topwaydisplay.com/Pub/Manual/LMB162ABC-Manual-Rev0.2.pdf
• 1 3 pin ribbon cable w connectors (for Arduino?)
• 1 74HC86N quad 2-input XOR gate
• 1 CD4026BE decade counter / 7-seg display driver
• 8 2N6027 programmable unijunction transistor
• 12 RGB (4 pin) LEDs.
• misc LEDs, mostly water clear 5mm. A few others.
• bag of resistors 470K
• 1 Piezo buzzer, TDK
• 2 PC mount relays, small KEST KS2E-M-DC12, 12v input, 125vac/1A contacts
• 1 big toggle switch, panel mount
• 1 3 pin opto device, probably an IR sensor, PC through hole, marked 340
• 1 red push button, panel mount
• 6 PC mount push buttons
• 1 2xAA battery holder
• Coax 2.5 mm power connectors (1 male, 2 female)
• 1 9V battery connector
• 7 alligator clips
• 2 proto boards, 7x9cm BNK
• 1 proto board
• 1 piece of perf board
• 1 DIP chip extractor
• 2 pieces of heat shrink tubing
• 2 pager motors
• 1 tiny speaker (or mic?)
• 1 Makershed Albercook Scientific "super cap racer" kit http://makezine.com/2011/12/19/new-in-the-maker-shed-super-cap-racers/ which includes
  • 2 pin power cable with pc mount header
  • 1 5V 0.1F supercap, PowerStore Aerogel
  • 1 PC mount microswitch
  • 1 3xAAA battery holder
  • 1 piece of wire (the tail)
  • 2 rubber caps used as tires